QA Wall & Ceiling
A high opacity, non-yellowing, acrylic flat paint. Its lack of sheen aids in covering minor surface imperfections.
Typical Uses
Recommended for broad wall & ceilings & areas in lounge rooms, dining areas, bedrooms, & passages.
Properties
Colour : complete colour range available
Gloss Level : low gloss
Durability : good for interior use or in protected areas externally
Solvent resistance : sensitive to aromatic hydrocarbons & alcohols
Toxicity : non toxic , lead & mercury free
Theoretical spreading rate at recommended dry film build – assumes no losses. Two coats are recommended each with a spreading rate of 16m² per litre at recommended 22 micrometres dry film build corresponding to an overall rate of 8m² per litre at 44 micrometres dry film build. Spreading rate will vary depending on such factors as nature of surface application method & application conditions.
Theoretical volume solids 35%
Surface preparation
Surfaces to be painted should be dry & free from dust, grease & dirt. Remove flaking & powdering paint & repair surface imperfections with a suitable filler.
Application
Stir well & apply liberally straight from the can. This paint has been specially formulated for rolling but may also be applied by brush or spray. Use a short nape roller. Avoid excessive brushing or rolling back into paint which has been drying for some minutes. Dampen very porous, dry surfaces & add 100ml water per litre to the first coat only.
Drying time Touch -dry in 30 minutes. Recoat after two hours. In damp & humid conditions drying time is lengthened
Equipment clean up Water