Name: QA Aqua Epoxy
SKU: 30
Price: 280.00 AUD
Availability: InStock

Water based – easy clean up using water
Non flammable, low odour, easy to apply
Economical
Excellent adhesion to dry & damp surfaces including freshly laid (hardened) concrete
Cured membrane will withstand hydrostatic pressure
Environmentally friendly, safe to use in sensitive locations
Good resistance to a wide range of chemicals
Can be overcoated with most decorative, industrial finishes & adhesives

Surface Preparation All surfaces must be structurally sound, free of any coatings, adhesives, grease, oil, form release agents, curing compounds, dirt/dust and any other surface contaminants.
Non structural cracks, holes and any other suface deformities to be rectified. Prime the surface with QA Aqua Epoxy while still tacky, fill voids with a mortar made from one part QA Aqua Epoxy mix, two parts sand/cement mix.
Leave at least two hours before over-coating with QA Aqua Epoxy. Should sanding be required leave a minimum of 12 hours and allow to cure prior to the application of QA Aqua Epoxy.
Efflorescence must be removed either by high pressure cleaning or a 5% hydrochloric acid solution.
Although QA Aqua Epoxy may be applied to a damp surface do not apply to surfaces having free water. Very dry, porous surfaces must be dampened with a fine mist first.

Treatment of rising damp, as a low water vapour transmission coating
As a waterproofing barrier to prevent the ingress of water through below grade concrete or masonry structures ie basements, tunnels, liftwells
To prevent water seepage, dampness penetration through to the interior of walls and floors
As a waterproof barrier, seal coating prior to overcoating with other coatings
As a waterproof barrier over freshly laid (hardened) concrete, prior to the installation of conventional carpet & tile adhesives

Surface Preparation All surfaces must be structurally sound, free of any coatings, adhesives, grease, oil, form release agents, curing compounds, dirt/dust and any other surface contaminants.
Non structural cracks, holes and any other suface deformities to be rectified. Prime the surface with QA Aqua Epoxy while still tacky, fill voids with a mortar made from one part QA Aqua Epoxy mix, two parts sand/cement mix.
Leave at least two hours before over-coating with QA Aqua Epoxy. Should sanding be required leave a minimum of 12 hours and allow to cure prior to the application of QA Aqua Epoxy.
Efflorescence must be removed either by high pressure cleaning or a 5% hydrochloric acid solution.
Although QA Aqua Epoxy may be applied to a damp surface do not apply to surfaces having free water. Very dry, porous surfaces must be dampened with a fine mist first.

Mix each component individually to a homogeneous blend. Thoroughly mix the two components in the ratio of 1:1 by volume (equal portions Parts A&B) until a homogeneous blend is achieved.
Avoid excessive and high speed blending. Mix only the amount of product to be used in pot life.
QA Aqua Epoxy may be applied by brush, roller or spray or either of the following combinations – squeegee/roller, broom/roller.
On dry, porous surfaces the first coat may be thinned with up to 10% fresh clean water. To ensure optimum performance, thinning of additional coats should be avoided.
Horizontal Spread the material using a squeegee or stiff nylon broom to achieve coverage and finish with a long nap roller.
Vertical Apply product by roller or spray. Several coats may be needed to achieve the required film build. The product will be touch dry in approximately 30 minutes (under normal conditions) & may be overcoated after 2 hours drying.

QA Aqua Epoxy